多个接收器用于单个EMS Q

Question

I have deployed a process in tibco admin and one of the queue(Q in the process starter of this process) configured has always 2 receivers. I am not sure why this is happening. if i stop this process then it goes to 0 receivers.i have also verified the JMS connections of 2 queues and it is one and the same. Could someone shed some light on this issue

Answer 1

Maybe you deployed it in TIBCO Administrator but in LB (Load Balance) mode so in that case, you will have 2 service instances with 2 JMS connections, as well. Try to check it.

Answer 2

另一种可能性是将“ JMS队列接收器”上的“最大会话数”设置为2。如果是这种情况，那么“接收器计数”将显示为2。

Answer 3

不幸的是，我在项目中有两次相同的过程。