Xcode 6: “Simulator in Use” error shows even though the simulator is NOT in use
Question
With the new Xcode 6, sometimes when I switch between simulators - I receive the error message "Simulator in Use - The Simulator can't be launched because it's already in use". However, the simulator is NOT in use - and I don't see it in the Activity Monitor either. The only way to overcome this is to exit and reenter Xcode.
Has anyone found an easier way to overcome this annoying error?
3 answers
solution1
2 2014-10-01 22:04:29
Yes, I have experienced similar thing.
I basically do what you do - exit and re-enter Xcode.
What I have discovered is that when you stop the simulator, don't run it / switch to another and run it so quickly. Give a second or two before running would avoid the problem (in my case) 90%.
This is not the case only for Xcode 6, earlier versions had this problem, too, when one stops and runs very quickly.
solution2
2 2014-11-06 07:15:58
I have faced this issue so many times this issue, you just close and reopen the Xcode . It will go for sure . Make sure no other Xcode should be running. If you have multiple Xcode then quit all of them.
solution3
0 2014-11-06 07:11:57
I figure it out. You don't need to close Xcode for that. I have explain every thing in details.
Follow this answer:
The technical post webpages of this site follow the CC BY-SA 4.0 protocol. If you need to reprint, please indicate the site URL or the original address.Any question please contact:yoyou2525@163.com.