I am trying to install swirl in R ver 3.4.1 32-bit on Debian wheezyx and am getting errors. Please see below:
------------------------- ANTICONF ERROR ---------------------------
Configuration failed because libcurl was not found. Try installing:
* deb: libcurl4-openssl-dev (Debian, Ubuntu, etc)
* rpm: libcurl-devel (Fedora, CentOS, RHEL)
* csw: libcurl_dev (Solaris)
If libcurl is already installed, check that 'pkg-config' is in your
PATH and PKG_CONFIG_PATH contains a libcurl.pc file. If pkg-
config
is unavailable you can set INCLUDE_DIR and LIB_DIR manually via:
R CMD INSTALL --configure-vars='INCLUDE_DIR=... LIB_DIR=...'
--------------------------------------------------------------------
ERROR: configuration failed for package 'curl'
* removing '/usr/local/lib/R/site-library/curl'
* installing *source* package 'openssl' ...
** package 'openssl' successfully unpacked and MD5 sums
checked
Found pkg-config cflags and libs!
Using PKG_CFLAGS=
Using PKG_LIBS=-lssl -lcrypto
------------------------- ANTICONF ERROR ---------------------------
Configuration failed because openssl was not found. Try installing:
* deb: libssl-dev (Debian, Ubuntu, etc)
* rpm: openssl-devel (Fedora, CentOS, RHEL)
* csw: libssl_dev (Solaris)
* brew: openssl@1.1 (Mac OSX)
If openssl is already installed, check that 'pkg-config' is in your
PATH and PKG_CONFIG_PATH contains a openssl.pc file. If pkg-
config
is unavailable you can set INCLUDE_DIR and LIB_DIR manually via:
R CMD INSTALL --configure-vars='INCLUDE_DIR=... LIB_DIR=...'
--------------------------------------------------------------------
I then tried to install libcurl4-openssl-dev but get the following error. I'm not sure what to do next...
> install.packages("libcurl4-openssl-dev")
Installing package into '/usr/local/lib/R/site-library'
(as 'lib' is unspecified)
Warning message:
package 'libcurl4-openssl-dev' is not available (for R version 3.4.1)
>
I tried to install libcurl4-openssl-dev
as a Debian package and this is the output I received.
Setting up dropbear (2014.65-1+deb8u2) ...
Restarting Dropbear SSH server: invoke-rc.d: initscript
dropbear, action "restart" failed.
dpkg: error processing package dropbear (--
configure):
subprocess installed post-installation script returned
error exit status 1
Errors were encountered while processing:
dropbear
E: Sub-process /usr/bin/dpkg returned an error code
(1)
After I run the package the issue still exist.
First try from the terminal:
sudo apt-get install libcurl4-openssl-dev libssl-dev
later go back to Rstudio and install swirl package again.
The technical post webpages of this site follow the CC BY-SA 4.0 protocol. If you need to reprint, please indicate the site URL or the original address.Any question please contact:yoyou2525@163.com.