I have added some project outputs (which produces some exes) to my Setup project.
After the setup project finishes doing all the things, the last thing that I want to do this is to run one of these exes from the from the project output.
How can this be done? This is not exactly similar to, but is fairly similar to Launch after install
thing in setups.
I usually do this through the post build event of the install project. This link should be a good start for you
The technical post webpages of this site follow the CC BY-SA 4.0 protocol. If you need to reprint, please indicate the site URL or the original address.Any question please contact:yoyou2525@163.com.