简体繁体中英

Newbie question about programming Altera Cyclone II in Quartus II

原文 2018-11-16 10:24:22 4 1 fpga/ intel-fpga/ cyclone

I bought a cheap board with Altera Cyclone II from ebay and want to start experimenting.

I created a simple program, after some research I managed to compile it and after flashing to the board the programming tool said it is 100% complete.

However the behaviour of the board has not changed since the time I first plugged the power supply in(three onboard LEDs are blinking).

It looks like the program has not been loaded to the board.

I don't know what I did wrong.

Any ideas? I am completely new to FPGAs. Thank you

1 answers

Normally the configuration stream is written into fpga sram, and it won't live across the power cycle. If you want that configuration be "permanent", write it into on-board configuration flash chip.

Did you check with this short introduction: http://laurie.tech/start-fpga/ ?

How to implement a watchdog timer on a Cyclone II FPGA in quartus ii

Loading a .txt file into FPGA using Quartus II?

Quartus II : simple counter but weird behaviour

Is an inferred latch in Quartus II necessarily transparent

Quartus Programmer II TCL flash *.pof file

Weird behavior of registers on Quartus II using Verilog

How to change pin voltage in quartus ii?

Quartus II : can't determine definition of operator “”<=“”

I am using ModelSim Altera 10.3d Quartus II 15.0 starter edition. When I open it I get an error message

Cyclone II FPGA active serial using usb blaster

暂无

The technical post webpages of this site follow the CC BY-SA 4.0 protocol. If you need to reprint, please indicate the site URL or the original address.Any question please contact:yoyou2525@163.com.

Related Question How to implement a watchdog timer on a Cyclone II FPGA in quartus ii Loading a .txt file into FPGA using Quartus II? Quartus II : simple counter but weird behaviour Is an inferred latch in Quartus II necessarily transparent Quartus Programmer II TCL flash *.pof file Weird behavior of registers on Quartus II using Verilog How to change pin voltage in quartus ii? Quartus II : can't determine definition of operator “”<=“” I am using ModelSim Altera 10.3d Quartus II 15.0 starter edition. When I open it I get an error message Cyclone II FPGA active serial using usb blaster

Related Tags

Newbie question about programming Altera Cyclone II in Quartus II

Question

1 answers

solution1 1 2018-11-16 18:04:33

solution1
1 2018-11-16 18:04:33